Model BT-60-D Ultrasonic Tank with Generator

2 ultrasonic cleaning chambers in one tank

The BT-60D Ultrasonic Cleaning System combines both heated ultrasonic cleaning and Ultrasonic overflow rinsing in the same tank. The tank is divided into two compartments each with its own independent drain. The rinse compartment has an additional overflow and fill port. All ports are 3/4".

The Ultrasonics Operate Simultaneously in both compartments. A power intensity control and sweep frequency control allows full adjustment of cleaning parameters. Both compartments are heated, each side having 500 watts of thermostatically controlled Heat.  A needle valve in the rinse compartment allows you to set the overflow rate.

The BT-60D is a complete cleaning system in one Ultrasonic Tank. The system may be used as a table top system or flush mounted in a cart. An additional spray rinse tank is available for the cart mounted version. With the addition of the cart and the spray rinse tank the BT-60D system is a complete mini console that has exactly the same cleaning capabilities as any production system.

The BT-60 System is ideal for pre-production cleaning and Laboratory Cleaning. Since the BT-60-D has the same ultrasonics and heat capabilities as production systems there is no difficulty in transferring the cleaning process to production. The BT 60-D may be used on a table top or flush mounted in a console.

Each BT-60D system is a dual frequency ultrasonic system. The operator can choose between 2 independent frequencies. With the addition of a 2nd  Generator, The system can be run at all three frequencies, simply by switching the generator or a toggle switch. The BT-D series tanks are available in the following sizes.

UC-60 Ultra Clean Ultrasonic Tank

Our Ultra Clean series are designed for maximum shedding of particulates. The coved inner surfaces of the tank along with the electro-polished interior inhibit the retention of particles. All our Ultra Clean tanks include a built in overflow at the rear of the tank. There are ports provided for fill, drain, sensors and re-circulation as well as for a 3/4" thermocouple well for direct reading of interior solution temperature. Temperature control can be either digital or thermostatic. The tanks are designed to stand alone or flush mount in a console.

The choice of frequencies is determined by your particular process requirements. A high  frequency is a better choice for delicate parts that require ultra fine particulate removal,  the higher frequency distributes the ultrasonic energy more evenly and creates smaller  cavities therefore it is able to remove smaller particulates. Lower frequencies are better  for removing heavy oils, fingerprints and large particulates. 

There are applications where A choice of Ultrasonic frequencies are available at  40 /68 /170 kHz . Up to 2 frequencies can be installed on the same tank. A separate generator  is supplied so that each frequency can be either simultaneously or independently activated. Custom versions with up to 4 overflows are available. Each tank is designed to be used either  as a detergent ultrasonic tank or an ultrasonic overflow rinse tank.